Airworthiness Directives; Saab Model SAAB 2000 Series Airplanes

[Federal Register Volume 65, Number 229 (Tuesday, November 28, 2000)]
[Rules and Regulations]
[Pages 70780-70781]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 00-29604]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 2000-NM-221-AD; Amendment 39-11997; AD 2000-23-24]
RIN 2120-AA64


Airworthiness Directives; Saab Model SAAB 2000 Series Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD), 
applicable to certain Saab Model SAAB 2000 series airplanes, that 
requires an inspection to ensure correct installation of certain self-
seal couplings in each nacelle, and corrective action, if necessary. 
This amendment also requires installation of a new clamp to the self-
seal couplings. This action is necessary to prevent separation of the 
self-seal couplings, which could result in loss of engine oil pressure 
and a flight-crew-commanded engine shutdown. This action is intended to 
address the identified unsafe condition.

DATES: Effective January 2, 2001.
    The incorporation by reference of certain publications listed in 
the regulations is approved by the Director of the Federal Register as 
of January 2, 2001.

ADDRESSES: The service information referenced in this AD may be 
obtained from Saab Aircraft AB, SAAB Aircraft Product Support, S-
581.88, Linkoping, Sweden. This information may be examined at the 
Federal Aviation Administration (FAA), Transport Airplane Directorate, 
Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the 
Office of the Federal Register, 800 North Capitol Street, NW., suite 
700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: Norman B. Martenson, Manager, 
International Branch, ANM-116, FAA, Transport Airplane Directorate, 
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 
227-2110; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal 
Aviation Regulations (14 CFR part 39) to include an airworthiness 
directive (AD) that is applicable to certain Saab Model SAAB 2000 
series airplanes was published in the Federal Register on September 29, 
2000 (65 FR 58494). That action proposed to require an inspection to 
ensure correct installation of certain self-seal couplings in each 
nacelle, and corrective action, if necessary. That action also proposed 
to require installation of a new clamp to the self-seal couplings.

Comments

    Interested persons have been afforded an opportunity to participate 
in the making of this amendment. No comments were submitted in response 
to the proposal or the FAA's determination of the cost to the public.

Conclusion

    The FAA has determined that air safety and the public interest 
require the adoption of the rule as proposed.

Cost Impact

    The FAA estimates that 3 Model SAAB 2000 series airplanes of U.S. 
registry will be affected by this AD, that it will take approximately 1 
work hour per airplane to accomplish the required actions, and that the 
average labor rate is $60 per work hour. Required parts will be 
provided by the vendor at no charge to operators. Based on these 
figures, the cost impact of the required AD on U.S. operators is 
estimated to be $180, or $60 per airplane.
    The cost impact figure discussed above is based on assumptions that 
no operator has yet accomplished any of the requirements of this AD 
action, and that no operator would accomplish those actions in the 
future if this AD were not adopted. The cost impact figures discussed 
in AD rulemaking actions represent only the time necessary to perform 
the specific actions actually required by the AD. These figures 
typically do not include incidental costs, such as the time required to 
gain access and close up, planning time, or time necessitated by other 
administrative actions.

Regulatory Impact

    The regulations adopted herein will not have a substantial direct 
effect on the States, on the relationship between the national 
Government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, it 
is determined that this final rule does not have federalism 
implications under Executive Order 13132.
    For the reasons discussed above, I certify that this action (1) is 
not a ``significant regulatory action'' under Executive Order 12866; 
(2) is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
significant economic impact, positive or negative, on a substantial 
number of small entities

[[Page 70781]]

under the criteria of the Regulatory Flexibility Act. A final 
evaluation has been prepared for this action and it is contained in the 
Rules Docket. A copy of it may be obtained from the Rules Docket at the 
location provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration amends part 39 of 
the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding the following new 
airworthiness directive:

000-23-24  Saab Aircraft AB:
    Amendment 39-11997. Docket 2000-NM-221-AD.

    Applicability: Model SAAB 2000 series airplanes, certificated in 
any category, having serial numbers -004 through -063 inclusive.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an 
alternative method of compliance in accordance with paragraph (b) of 
this AD. The request should include an assessment of the effect of 
the modification, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.

    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent separation of the self-seal couplings, which could 
result in loss of engine oil pressure and a flight-crew-commanded 
engine shutdown, accomplish the following:

Inspection, Installation and Corrective Actions

    (a) Within 3 months after the effective date of this AD, perform 
a one-time general visual inspection to ensure correct installation 
of the air-cooled oil cooler (ACOC) self-seal couplings in each 
nacelle, and install a new clamp to the self-seal couplings, in 
accordance with Saab Service Bulletin 2000-79-005, dated May 22, 
2000. If any coupling is installed incorrectly, prior to further 
flight, perform the corrective actions specified in the service 
bulletin in accordance with the procedures specified in the service 
bulletin.

    Note 2: For the purposes of this AD, a general visual inspection 
is defined as: ``A visual examination of an interior or exterior 
area, installation, or assembly to detect obvious damage, failure, 
or irregularity. This level of inspection is made under normally 
available lighting conditions such as daylight, hangar lighting, 
flashlight, or drop-light, and may require removal or opening of 
access panels or doors. Stands, ladders, or platforms may be 
required to gain proximity to the area being checked.''

Alternative Methods of Compliance

    (b) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, International Branch, ANM-116, FAA, 
Transport Airplane Directorate. Operators shall submit their 
requests through an appropriate FAA Principal Maintenance Inspector, 
who may add comments and then send it to the Manager, International 
Branch, ANM-116.

    Note 3: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the International Branch, ANM-116.

Special Flight Permits

    (c) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the airplane to a location where 
the requirements of this AD can be accomplished.

Incorporation by Reference

    (d) The actions shall be done in accordance with Saab Service 
Bulletin 2000-79-005, dated May 22, 2000. This incorporation by 
reference was approved by the Director of the Federal Register in 
accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be 
obtained from Saab Aircraft AB, SAAB Aircraft Product Support, S-
581.88, Link&oping, Sweden. Copies may be inspected at the FAA, 
Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, 
Washington; or at the Office of the Federal Register, 800 North 
Capitol Street, NW., suite 700, Washington, DC.

    Note 4: The subject of this AD is addressed in Swedish 
airworthiness directive 1-158, dated May 23, 2000.

Effective Date

    (e) This amendment becomes effective on January 2, 2001.

    Issued in Renton, Washington, on November 14, 2000.
Donald L. Riggin,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 00-29604 Filed 11-27-00; 8:45 am]
BILLING CODE 4910-13-P

The complete text was extracted from the official GovInfo HTML edition for this publication. Acquired 2026-10-09T04:34:34.452700+00:00. Text extraction preserves the recorded source wording; it does not determine current requirements.

Open the captured official edition

Source SHA-256

70227468f45c0b03f8c8ab1634a2e5a4c98e70ad1a53a75b819ccf8fdb4eb9e9

Text SHA-256

2b7a0b10802923216358730b1898d2cc863433b58328674e36a40a817b7386eb