Airworthiness Directives; Eurocopter France Model SA-366G1 Helicopters

[Federal Register Volume 65, Number 76 (Wednesday, April 19, 2000)]
[Rules and Regulations]
[Pages 20894-20895]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 00-9820]


=======================================================================
-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 99-SW-14-AD; Amendment 39-11692; AD 2000-08-06]
RIN 2120-AA64


Airworthiness Directives; Eurocopter France Model SA-366G1 
Helicopters

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD), 
applicable to Eurocopter France Model SA-366G1 helicopters, that 
requires replacing certain electrical modules with airworthy electrical 
modules. This amendment is prompted by the discovery of several 
defective electrical modules. The actions specified by this AD are 
intended to prevent loss of electrical continuity, which could cause 
loss of critical systems and subsequent loss of control of the 
helicopter.

EFFECTIVE DATE: May 24, 2000.

FOR FURTHER INFORMATION CONTACT: Robert McCallister, Aerospace 
Engineer, FAA, Rotorcraft Directorate, Rotorcraft Standards Staff, Fort 
Worth, Texas 76193-0110, telephone (817) 222-5121, fax (817) 222-5961.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal 
Aviation Regulations (14 CFR part 39) to include an airworthiness 
directive (AD) that is applicable to Eurocopter France Model SA-366G1 
helicopters was published in the Federal Register on January 10, 2000 
(65 FR 1353). That action proposed to require replacing certain 
electrical modules with airworthy electrical modules.
    Interested persons have been afforded an opportunity to participate 
in the making of this amendment. No comments were received on the 
proposal or the FAA's determination of the cost to the public. The FAA 
has determined that air safety and the public interest require the 
adoption of the rule as proposed.
    The FAA estimates that 94 helicopters of U.S. registry will be 
affected by this AD, that it will take approximately 100 work hours per 
helicopter to accomplish the required actions, and that the average 
labor rate is $60 per work hour. Required parts will cost approximately 
$2,969 for the maximum number of modules replaced per helicopter, but 
the manufacturer has stated that the parts will be provided at no cost. 
Based on these figures, the total cost impact of the AD on U.S. 
operators is estimated to be $564,000.
    The regulations adopted herein will not have a substantial direct 
effect on the States, on the relationship between the national 
Government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, it 
is determined that this final rule does not have federalism 
implications under Executive Order 13132.
    For the reasons discussed above, I certify that this action (1) is 
not a ``significant regulatory action'' under Executive Order 12866; 
(2) is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
significant economic impact, positive or negative, on a substantial 
number of small entities under the criteria of the Regulatory 
Flexibility Act. A final evaluation has been prepared for this action 
and it is contained in the Rules Docket. A copy of it may be obtained 
from the Rules Docket at the Office of the Regional Counsel, Southwest 
Region, 2601 Meacham Blvd., Room 663, Fort Worth, Texas.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Safety.

Adoption of the Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration amends part 39 of 
the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding a new airworthiness directive 
to read as follows:

AD 2000-08-06  Eurocopter France: Amendment 39-11692. Docket No. 99-
SW-14-AD.
    Applicability: Model SA-366G1 helicopters, certificated in any 
category.

    Note 1: This AD applies to each helicopter identified in the 
preceding applicability provision, regardless of whether it has been 
otherwise modified, altered, or repaired in the area subject to the 
requirements of this AD. For helicopters that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an 
alternative method of compliance in accordance with paragraph (b) of 
this AD. The request should include an assessment of the effect of 
the modification, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.

    Compliance: Required within 400 hours time-in-service or within 
6 calendar months, whichever occurs first, unless accomplished 
previously.
    To prevent loss of electrical continuity, which could cause loss 
of required systems and subsequent loss of control of the 
helicopter, accomplish the following:
    (a) Replace each ``CONNECTRAL'' green electrical module that 
does not have a white dot on the face and that has a manufacturing 
code of 95/16 through 96/21 with an airworthy electrical module. 
Those manufacturing codes identify modules manufactured between the 
beginning of the 16th week of 1995 and the end of the 21st week of 
1996.

    Note 2: Eurocopter France Service Bulletin No. 01.25, dated May 
28, 1998, pertains to the subject of this AD.

    (b) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, Regulations Group, Rotorcraft 
Directorate, FAA. Operators shall submit their requests through an 
FAA Principal Maintenance Inspector, who may concur or comment and 
then send it to the Manager, Regulations Group.

    Note 3: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the Regulations Group.

    (c) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the helicopter to a location where 
the requirements of this AD can be accomplished.
    (d) This amendment becomes effective on May 24, 2000.

    Note 4: The subject of this AD is addressed in Direction 
Generale De L'Aviation Civile AD 98-251-022(A), dated July 1, 1998.



[[Page 20895]]


    Issued in Fort Worth, Texas, on April 11, 2000.
Henry A. Armstrong,
Manager, Rotorcraft Directorate, Aircraft Certification Service.
[FR Doc. 00-9820 Filed 3-18-00; 8:45 am]
BILLING CODE 4910-13-U

The complete text was extracted from the official GovInfo HTML edition for this publication. Acquired 2026-10-09T04:40:26.453330+00:00. Text extraction preserves the recorded source wording; it does not determine current requirements.

Open the captured official edition

Source SHA-256

22e934fafa512cec0d1c137f80e2b537ee02b3c5ed54169822cd417d266ed882

Text SHA-256

ff5269b18687483b38eba5864c6afe40afd0c8d5d664f710e85605371410291e