Airworthiness Directives; Construcciones Aeronauticas, S.A. (CASA) Model CN-235 Series Airplanes

[Federal Register Volume 66, Number 117 (Monday, June 18, 2001)]
[Rules and Regulations]
[Pages 32729-32731]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 01-15089]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 2000-NM-273-AD; Amendment 39-12267; AD 2001-12-12]
RIN 2120-AA64


Airworthiness Directives; Construcciones Aeronauticas, S.A. 
(CASA) Model CN-235 Series Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD),

[[Page 32730]]

applicable to certain CASA Model CN-235 series airplanes, that requires 
installation of fuselage skin reinforcements in the right and left 
zones of the fuselage between stations 11232 and 11740 and stringers P7 
and P9. The actions specified by this AD are intended to prevent 
premature fatigue cracking of the fuselage, which could result in 
reduced structural integrity of the airplane. This action is intended 
to address the identified unsafe condition.

DATES: Effective July 23, 2001.
    The incorporation by reference of certain publications listed in 
the regulations is approved by the Director of the Federal Register as 
of July 23, 2001.

ADDRESSES: The service information referenced in this AD may be 
obtained from Construcciones Aeronauticas, S.A., Getafe, Madrid, Spain. 
This information may be examined at the Federal Aviation Administration 
(FAA), Transport Airplane Directorate, Rules Docket, 1601 Lind Avenue, 
SW., Renton, Washington; or at the Office of the Federal Register, 800 
North Capitol Street, NW., suite 700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: Dan Rodina, Aerospace Engineer, 
International Branch, ANM-116, FAA, Transport Airplane Directorate, 
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 
227-2125; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal 
Aviation Regulations (14 CFR part 39) to include an airworthiness 
directive (AD) that is applicable to certain CASA Model CN-235 series 
airplanes was published in the Federal Register on April 10, 2001 (66 
FR 18573). That action proposed to require installation of fuselage 
skin reinforcements in the right and left zones of the fuselage between 
stations 11232 and 11740 and stringers P7 and P9.

Comments

    Interested persons have been afforded an opportunity to participate 
in the making of this amendment. No comments were submitted in response 
to the proposal or the FAA's determination of the cost to the public.

Conclusion

    The FAA has determined that air safety and the public interest 
require the adoption of the rule as proposed.

Cost Impact

    The FAA estimates that one Model CN-235 series airplane of U.S. 
registry will be affected by this AD, that it will take approximately 
45 work hours per airplane to accomplish the required actions, and that 
the average labor rate is $60 per work hour. Required parts will cost 
approximately $130 per airplane. Based on these figures, the cost 
impact of the AD on U.S. operators is estimated to be $2,830.
    The cost impact figure discussed above is based on assumptions that 
no operator has yet accomplished any of the requirements of this AD 
action, and that no operator would accomplish those actions in the 
future if this AD were not adopted. The cost impact figures discussed 
in AD rulemaking actions represent only the time necessary to perform 
the specific actions actually required by the AD. These figures 
typically do not include incidental costs, such as the time required to 
gain access and close up, planning time, or time necessitated by other 
administrative actions.

Regulatory Impact

    The regulations adopted herein will not have a substantial direct 
effect on the States, on the relationship between the national 
Government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, it 
is determined that this final rule does not have federalism 
implications under Executive Order 13132.
    For the reasons discussed above, I certify that this action (1) is 
not a ``significant regulatory action'' under Executive Order 12866; 
(2) is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
significant economic impact, positive or negative, on a substantial 
number of small entities under the criteria of the Regulatory 
Flexibility Act. A final evaluation has been prepared for this action 
and it is contained in the Rules Docket. A copy of it may be obtained 
from the Rules Docket at the location provided under the caption 
ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration amends part 39 of 
the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding the following new 
airworthiness directive:

2001-12-12  Construcciones Aeronauticas, S.A. (CASA): Amendment 39-
12267. Docket 2000-NM-273-AD.

    Applicability: Model CN-235 series airplanes, serial numbers C-
041 and C-042, certificated in any category.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an 
alternative method of compliance in accordance with paragraph (b) of 
this AD. The request should include an assessment of the effect of 
the modification, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.

    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent fatigue cracking of the fuselage, which could result 
in reduced structural integrity of the airplane, accomplish the 
following:

Reinforcement of Fuselage Skin

    (a) Prior to the accumulation of 15,000 total flight cycles, 
install fuselage skin reinforcements between stations 11232 and 
11740 and stringers P7 and P9, on both the right and left zones of 
the fuselage, in accordance with CASA Service Bulletin SB-235-53-40, 
dated June 16, 1994.

Alternative Methods of Compliance

    (b) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, International Branch, ANM-116, 
Transport Airplane Directorate, FAA. Operators shall submit their 
requests through an appropriate FAA Principal Maintenance Inspector, 
who may add comments and then send it to the Manager, International 
Branch, ANM-116.

    Note 2: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the International Branch, ANM-116.

Special Flight Permits

    (c) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the airplane to a location where 
the requirements of this AD can be accomplished.

[[Page 32731]]

Incorporation by Reference

    (d) The actions shall be done in accordance with CASA Service 
Bulletin SB-235-53-40, dated June 16, 1994. This incorporation by 
reference was approved by the Director of the Federal Register in 
accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be 
obtained from Construcciones Aeronauticas, S.A., Getafe, Madrid, 
Spain. Copies may be inspected at the FAA, Transport Airplane 
Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the 
Office of the Federal Register, 800 North Capitol Street, NW., suite 
700, Washington, DC.

    Note 3: The subject of this AD is addressed in Spanish 
airworthiness directive 01/2000, dated March 22, 2000.

Effective Date

    (e) This amendment becomes effective on July 23, 2001.

    Issued in Renton, Washington, on June 8, 2001.
Donald L. Riggin,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 01-15089 Filed 6-15-01; 8:45 am]
BILLING CODE 4910-13-U

The complete text was extracted from the official GovInfo HTML edition for this publication. Acquired 2026-10-09T04:29:04.629680+00:00. Text extraction preserves the recorded source wording; it does not determine current requirements.

Open the captured official edition

Source SHA-256

8fdaa0ccdaa549c652a748163782c6a42c76ef6e75013609f6c757af9aeba6d2

Text SHA-256

40a6e045d8b191b7082a68b9203b4da0e81790d7bdc828f22e609bb1efe5370e