Airworthiness Directives; Bombardier Model DHC-8-102, -103, and -301 Series Airplanes

[Federal Register Volume 66, Number 130 (Friday, July 6, 2001)]
[Rules and Regulations]
[Pages 35535-35536]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 01-16738]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 2000-NM-328-AD; Amendment 39-12303; AD 2001-13-21]
RIN 2120-AA64


Airworthiness Directives; Bombardier Model DHC-8-102, -103, and -
301 Series Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD), 
applicable to certain Bombardier Model DHC-8-102, -103, and -301 series 
airplanes, that requires repair of the flight deck angle. The actions 
specified by this AD are intended to prevent the flight deck angle from 
interfering with the clevis of the roll control disconnect cable, which 
could lead to an uncommanded disconnection of the roll control, 
resulting in reduced controllability of the airplane. This action is 
intended to address the identified unsafe condition.

DATES: Effective August 10, 2001.
    The incorporation by reference of certain publications listed in 
the regulations is approved by the Director of the Federal Register as 
of August 10, 2001.

ADDRESSES: The service information referenced in this AD may be 
obtained from Bombardier, Inc., Bombardier Regional Aircraft Division, 
123 Garratt Boulevard, Downsview, Ontario M3K 1Y5, Canada. This 
information may be examined at the Federal Aviation Administration 
(FAA), Transport Airplane Directorate, Rules Docket, 1601 Lind Avenue, 
SW., Renton, Washington; or at the FAA, New York Aircraft Certification 
Office, 10 Fifth Street, Third Floor, Valley Stream, New York; or at 
the Office of the Federal Register, 800 North Capitol Street, NW., 
Suite 700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: Dan Parrillo, Aerospace Engineer, 
Systems and Flight Test Branch, ANE-170, FAA, New York Aircraft 
Certification Office, 10 Fifth Street, Valley Stream, New York 11581-
1200; telephone (516) 256-7505; fax (516) 568-2716.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal 
Aviation Regulations (14 CFR part 39) to include an airworthiness 
directive (AD) that is applicable to certain Bombardier Model DHC-8-
102, -103, and -301 series airplanes was published in the Federal 
Register on April 12, 2001 (66 FR 18877). That action proposed to 
require repair of the flight deck angle.

Comments

    Interested persons have been afforded an opportunity to participate 
in the making of this amendment. No comments were submitted in response 
to the proposal or the FAA's determination of the cost to the public.

Conclusion

    The FAA has determined that air safety and the public interest 
require the adoption of the rule as proposed.

Cost Impact

    The FAA estimates that 42 Bombardier Model DHC-8-102, -103, and -
301 series airplanes of U.S. registry will be affected by this AD, that 
it will take approximately 4 work hours per airplane to accomplish the 
required repair, and that the average labor rate is $60 per work hour. 
Based on these figures, the cost impact of the AD on U.S. operators is 
estimated to be $10,080, or $240 per airplane.
    The cost impact figure discussed above is based on assumptions that 
no operator has yet accomplished any of the requirements of this AD 
action, and that no operator would accomplish those actions in the 
future if this AD were not adopted. The cost impact figures discussed 
in AD rulemaking actions represent only the time necessary to perform 
the specific actions actually required by the AD. These figures 
typically do not include incidental costs, such as the time required to 
gain access and close up, planning time, or time necessitated by other 
administrative actions.

Regulatory Impact

    The regulations adopted herein will not have a substantial direct 
effect on the States, on the relationship between the national 
Government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, it 
is determined that this final rule does not have federalism 
implications under Executive Order 13132.
    For the reasons discussed above, I certify that this action (1) is 
not a ``significant regulatory action'' under Executive Order 12866; 
(2) is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
significant economic impact, positive or negative, on a substantial 
number of small entities under the criteria of the Regulatory 
Flexibility Act. A final evaluation has

[[Page 35536]]

been prepared for this action and it is contained in the Rules Docket. 
A copy of it may be obtained from the Rules Docket at the location 
provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration amends part 39 of 
the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding the following new 
airworthiness directive:

2001-13-21  Bombardier, Inc. (Formerly de Havilland, Inc.): 
Amendment 39-12303. Docket 2000-NM-328-AD.

    Applicability: Model DHC-8-102, -103, and -301 series airplanes, 
certificated in any category, serial numbers 003 through 146, 
excluding serial numbers 064 and 137.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an 
alternative method of compliance in accordance with paragraph (b) of 
this AD. The request should include an assessment of the effect of 
the modification, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.

    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent the flight deck angle from interfering with the 
clevis of the roll control disconnect cable, which could lead to an 
uncommanded disconnection of the roll control, resulting in reduced 
controllability of the airplane, accomplish the following:

Repair

    (a) Within 18 months after the effective date of this AD: Repair 
the flight deck angle having part number (P/N) 85310497-101/103, by 
accomplishing all applicable actions specified in the Accomplishment 
Instructions of Bombardier Service Bulletin 8-53-75, dated December 
6, 1999, in accordance with the service bulletin.

    Note 2: The service bulletin references Bombardier Repair 
Drawing RD8-53-3620, dated June 15, 1999, as an additional source of 
service information for accomplishment of the repair of the flight 
deck angle.

Alternative Methods of Compliance

    (b) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, New York Aircraft Certification 
Office (ACO), FAA. Operators shall submit their requests through an 
appropriate FAA Principal Maintenance Inspector, who may add 
comments and then send it to the Manager, New York ACO.

    Note 3: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the New York ACO.

Special Flight Permits

    (c) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the airplane to a location where 
the requirements of this AD can be accomplished.

Incorporation by Reference

    (d) The repair shall be done in accordance with Bombardier 
Service Bulletin 8-53-75, dated December 6, 1999. This incorporation 
by reference was approved by the Director of the Federal Register in 
accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be 
obtained from Bombardier, Inc., Bombardier Regional Aircraft 
Division, 123 Garratt Boulevard, Downsview, Ontario M3K 1Y5, Canada. 
Copies may be inspected at the FAA, Transport Airplane Directorate, 
1601 Lind Avenue, SW., Renton, Washington; or at the FAA, New York 
Aircraft Certification Office, 10 Fifth Street, Third Floor, Valley 
Stream, New York; or at the Office of the Federal Register, 800 
North Capitol Street, NW., suite 700, Washington, DC.

    Note 4: The subject of this AD is addressed in Canadian 
airworthiness directive CF-2000-21, dated August 4, 2000.

Effective Date

    (e) This amendment becomes effective on August 10, 2001.

    Issued in Renton, Washington, on June 26, 2001.
Vi L. Lipski,
Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 01-16738 Filed 7-5-01; 8:45 am]
BILLING CODE 4910-13-P

The complete text was extracted from the official GovInfo HTML edition for this publication. Acquired 2026-10-09T04:28:23.411287+00:00. Text extraction preserves the recorded source wording; it does not determine current requirements.

Open the captured official edition

Source SHA-256

281a9223382df9da016c737a045c4f30d9ce6eb1099e619b7f38768495ac9e94

Text SHA-256

a3dd537478ff61d91ee65ca1f6b796c9ce24186b9924e4cf23592f47866c59f7