Airworthiness Directives; Boeing Model 757-200 and -200CB Series Airplanes

[Federal Register Volume 69, Number 62 (Wednesday, March 31, 2004)]
[Rules and Regulations]
[Pages 16786-16787]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 04-6954]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 2000-NM-404-AD; Amendment 39-13551; AD 2004-07-07]
RIN 2120-AA64


Airworthiness Directives; Boeing Model 757-200 and -200CB Series 
Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment supersedes an existing airworthiness directive 
(AD), applicable to certain Boeing Model 757-200 series airplanes, that 
currently requires modifications to the attachment installation of the 
forward lavatory. This amendment adds airplanes to the applicability of 
the existing AD. The actions specified by this AD are intended to 
prevent failure of the attachment installation of the forward lavatory 
during an emergency landing, which could result in injury to the crew 
and passengers. This action is intended to address the identified 
unsafe condition.

DATES: Effective May 5, 2004.
    The incorporation by reference of Boeing Special Attention Service 
Bulletin 757-25-0181, Revision 1, dated November 21, 2000, as listed in 
the regulations, is approved by the Director of the Federal Register as 
of May 5, 2004.
    The incorporation by reference of Boeing Service Bulletin 757-25-
0181, dated June 26, 1997; and Boeing Alert Service Bulletin 757-
25A0187, dated September 18, 1997; as listed in the regulations, was 
approved previously by the Director of the Federal Register as of June 
1, 1999 (64 FR 20146, April 26, 1999).

ADDRESSES: The service information referenced in this AD may be 
obtained from Boeing Commercial Airplanes, P.O. Box 3707, Seattle, 
Washington 98124-2207. This information may be examined at the Federal 
Aviation Administration (FAA), Transport Airplane Directorate, Rules 
Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of 
the Federal Register, 800 North Capitol Street, NW., suite 700, 
Washington, DC.

FOR FURTHER INFORMATION CONTACT: David Crotty, Aerospace Engineer, 
Cabin Safety and Environmental Systems Branch, ANM-150S, FAA, Seattle 
Aircraft Certification Office, 1601 Lind Avenue, SW., Renton, 
Washington 98055-4056; telephone (425) 917-6422; fax (425) 917-6590.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal 
Aviation Regulations (14 CFR part 39) by superseding AD 99-09-13, 
amendment 39-11146 (64 FR 20146, April 26, 1999), which is applicable 
to certain Boeing Model 757-200 series airplanes, was published in the 
Federal Register on December 22, 2003 (68 FR 71051). The action 
proposed to continue to require modifications to the attachment 
installation of the forward lavatory. The action also proposed to add 
airplanes to the applicability of the existing AD.

Comments

    Interested persons have been afforded an opportunity to participate 
in the making of this amendment. No comments were submitted in response 
to the proposal or the FAA's determination of the cost to the public.

Conclusion

    The FAA has determined that air safety and the public interest 
require the adoption of the rule as proposed.

Cost Impact

    There are approximately 694 airplanes of the affected design in the 
worldwide fleet. The FAA estimates that 355 airplanes of U.S. registry 
will be affected by this AD.
    It will take approximately 4 work hours per airplane to accomplish 
the required modification, at an average labor rate of $65 per work 
hour. Required parts will cost approximately $100 per airplane. Based 
on these figures, the cost impact of the required

[[Page 16787]]

modification on U.S. operators is estimated to be $127,800, or $360 per 
airplane.
    The cost impact figures discussed above are based on assumptions 
that no operator has yet accomplished any of the requirements of this 
AD action, and that no operator would accomplish those actions in the 
future if this AD were not adopted. The cost impact figures discussed 
in AD rulemaking actions represent only the time necessary to perform 
the specific actions actually required by the AD. These figures 
typically do not include incidental costs, such as the time required to 
gain access and close up, planning time, or time necessitated by other 
administrative actions. The manufacturer may cover the cost of 
replacement parts associated with this AD, subject to warranty 
conditions. Manufacturer warranty remedies may also be available for 
labor costs associated with this AD. As a result, the costs 
attributable to the AD may be less than stated above.

Regulatory Impact

    The regulations adopted herein will not have a substantial direct 
effect on the States, on the relationship between the national 
Government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, it 
is determined that this final rule does not have federalism 
implications under Executive Order 13132.
    For the reasons discussed above, I certify that this action (1) is 
not a ``significant regulatory action'' under Executive Order 12866; 
(2) is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
significant economic impact, positive or negative, on a substantial 
number of small entities under the criteria of the Regulatory 
Flexibility Act. A final evaluation has been prepared for this action 
and it is contained in the Rules Docket. A copy of it may be obtained 
from the Rules Docket at the location provided under the caption 
ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

0
Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration amends part 39 of 
the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

0
1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec.  39.13  [Amended]

0
2. Section 39.13 is amended by removing amendment 39-11146 (64 FR 
20146, April 26, 1999), and by adding a new airworthiness directive 
(AD), amendment 39-13551, to read as follows:

2004-07-07 Boeing: Amendment 39-13551. Docket 2000-NM-404-AD. 
Supersedes AD 99-09-13, Amendment 39-11146.

    Applicability: Model 757-200 and -200CB series airplanes; as 
listed in Boeing Special Attention Service Bulletin 757-25-0181, 
Revision 1, dated November 21, 2000; and as listed in Boeing Alert 
Service Bulletin 757-25A0187, dated September 18, 1997; certificated 
in any category.
    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent failure of the attachment installation of the forward 
lavatory during an emergency landing, which could result in injury 
to the crew and passengers, accomplish the following:

Restatement of Requirements of AD 99-09-13

    (a) For passenger airplanes identified in Boeing Service 
Bulletin 757-25-0181, dated June 26, 1997: Within 24 months or 3,000 
flight cycles after June 1, 1999 (the effective date of AD 99-09-13, 
amendment 39-11146), whichever occurs first, install a doubler to 
the upper attachment installation of the forward lavatory, in 
accordance with Boeing Service Bulletin 757-25-0181, dated June 26, 
1997.
    (b) For freighter airplanes identified in Boeing Alert Service 
Bulletin 757-25A0187, dated September 18, 1997: Within 24 months or 
3,000 flight cycles after June 1, 1999, whichever occurs first, 
install floor panel inserts, a retention fitting assembly, and a 
doubler assembly to the lower attachment installation of the forward 
lavatory, in accordance with Boeing Alert Service Bulletin 757-
25A0187, dated September 18, 1997.

New Requirements of this AD

    (c) For passenger airplanes identified in Boeing Special 
Attention Service Bulletin 757-25-0181, Revision 1, dated November 
21, 2000, other than those identified in paragraph (a) of this AD: 
Within 24 months after the effective date of this AD, install a 
doubler to the upper attachment installation of the forward 
lavatory, in accordance with the Work Instructions of Boeing Special 
Attention Service Bulletin 757-25-0181, Revision 1, dated November 
21, 2000.

Parts Installation

    (d) As of the effective date of this AD, no person shall install 
a floor panel, part number 141N5410-12 or 141N5410-28, on any 
airplane.

    Note 1: Floor panels having part numbers 141N5410-12 and 
141N5410-28 are only installed on freighter airplanes and are not 
used on passenger airplanes.

Installations Accomplished Per Previous Issues of Service Bulletin

    (e) Installations accomplished before the effective date of this 
AD per the original issue of Boeing Special Attention Service 
Bulletin 757-25-0181, dated June 26, 1997, are considered acceptable 
for compliance with the actions specified in paragraph (c) of this 
AD.

Alternative Methods of Compliance

    (f)(1) In accordance with 14 CFR 39.19, the Manager, Seattle 
Aircraft Certification Office, FAA, is authorized to approve 
alternative methods of compliance (AMOCs) for this AD.
    (2) AMOCs, approved previously per AD 99-09-13, amendment 39-
11146, that provide for the installation of an oversize doubler to 
the upper attachment installation of the forward lavatory, are 
approved as AMOCs with this AD.

Incorporation by Reference

    (g) Unless otherwise specified in this AD, the actions shall be 
done in accordance with Boeing Service Bulletin 757-25-0181, dated 
June 26, 1997; Boeing Special Attention Service Bulletin 757-25-
0181, Revision 1, dated November 21, 2000; and Boeing Alert Service 
Bulletin 757-25A0187, dated September 18, 1997; as applicable.
    (1) This incorporation by reference of Boeing Special Attention 
Service Bulletin 757-25-0181, Revision 1, dated November 21, 2000, 
is approved by the Director of the Federal Register in accordance 
with 5 U.S.C. 552(a) and 1 CFR part 51.
    (2) The incorporation by reference of Boeing Service Bulletin 
757-25-0181, dated June 26, 1997; and Boeing Alert Service Bulletin 
757-25A0187, dated September 18, 1997; was approved previously by 
the Director of the Federal Register as of June 1, 1999 (64 FR 
20146, April 26, 1999).
    (3) Copies may be obtained from Boeing Commercial Airplanes, 
P.O. Box 3707, Seattle, Washington 98124-2207. Copies may be 
inspected at the FAA, Transport Airplane Directorate, 1601 Lind 
Avenue, SW., Renton, Washington; or at the Office of the Federal 
Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

Effective Date

    (h) This amendment becomes effective on May 5, 2004.

    Issued in Renton, Washington, on March 19, 2004.
Kevin M. Mullin,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 04-6954 Filed 3-30-04; 8:45 am]
BILLING CODE 4910-13-P

The complete text was extracted from the official GovInfo HTML edition for this publication. Acquired 2026-10-09T04:06:24.588987+00:00. Text extraction preserves the recorded source wording; it does not determine current requirements.

Open the captured official edition

Source SHA-256

af703acf568d05f403b1e6d9dc8a1143f97613b98210f82fb274e47c24072325

Text SHA-256

cd1cc18f11fa0b554069f0eb5f1fc7d04d9dbfcdeabdfaaf4e6c79307930ff89