Airworthiness Directives; Fokker Model F28 Mark 0100 Series Airplanes

[Federal Register Volume 60, Number 32 (Thursday, February 16, 1995)]
[Rules and Regulations]
[Pages 8927-8929]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 95-3247]



=======================================================================
-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 94-NM-118-AD; Amendment 39-9142; AD 95-03-05]


Airworthiness Directives; Fokker Model F28 Mark 0100 Series 
Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD), 
applicable to certain Fokker Model F28 Mark 0100 series airplanes, that 
requires an inspection to detect cracks in the cleats at certain rib 
stations of the wing, and replacement of the cracked cleats with new 
cleats. This amendment is prompted by a report that, during manufacture 
of the wings of these airplanes, cracks were discovered in the cleats 
at the left- and right-hand rib station 8200 of the wing due to 
improper installation of certain bolts. The actions specified by this 
AD are intended to prevent cracking of the cleats, which could result 
in reduced structural integrity of the wing.

DATES: Effective March 20, 1995.
    The incorporation by reference of certain publications listed in 
the regulations is approved by the Director of the Federal Register as 
of March 20, 1995.

ADDRESSES: The service information referenced in this AD may be 
obtained [[Page 8928]] from Fokker Aircraft USA, Inc., 1199 North 
Fairfax Street, Alexandria, Virginia 22314. This information may be 
examined at the Federal Aviation Administration (FAA), Transport 
Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, 
Washington; or at the Office of the Federal Register, 800 North Capitol 
Street, NW., suite 700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: Tim Dulin, Aerospace Engineer, 
Standardization Branch, ANM-113, FAA, Transport Airplane Directorate, 
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (206) 
227-2141; fax (206) 227-1320.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal 
Aviation Regulations (14 CFR part 39) to include an airworthiness 
directive (AD) that is applicable to certain Fokker Model F28 Mark 0100 
series airplanes was published in the Federal Register on October 18, 
1994 (59 FR 52481). That action proposed to require a one-time high-
frequency eddy current inspection to detect cracks of the cleats at the 
left- and right-hand rib station 8200 of the wing, and replacement of 
the cracked cleats with new cleats.
    Interested persons have been afforded an opportunity to participate 
in the making of this amendment. Due consideration has been given to 
the single comment received.
    The commenter supports the proposed rule.
    As a result of recent communications with the Air Transport 
Association (ATA) of America, the FAA has learned that, in general, 
some operators may misunderstand the legal effect of AD's on airplanes 
that are identified in the applicability provision of the AD, but that 
have been altered or repaired in the area addressed by the AD. The FAA 
points out that all airplanes identified in the applicability provision 
of an AD are legally subject to the AD. If an airplane has been altered 
or repaired in the affected area in such a way as to affect compliance 
with the AD, the owner or operator is required to obtain FAA approval 
for an alternative method of compliance with the AD, in accordance with 
the paragraph of each AD that provides for such approvals. A note has 
been added to this final rule to clarify this requirement.
    The FAA has recently reviewed the figures it has used over the past 
several years in calculating the economic impact of AD activity. In 
order to account for various inflationary costs in the airline 
industry, the FAA has determined that it is necessary to increase the 
labor rate used in these calculations from $55 per work hour to $60 per 
work hour. The economic impact information, below, has been revised to 
reflect this increase in the specified hourly labor rate.
    After careful review of the available data, including the comments 
noted above, the FAA has determined that air safety and the public 
interest require the adoption of the rule with the changes previously 
described. The FAA has determined that these changes will neither 
increase the economic burden on any operator nor increase the scope of 
the AD.
    The FAA estimates that 12 airplanes of U.S. registry will be 
affected by this AD, that it will take approximately 55 work hours per 
airplane to accomplish the required actions, and that the average labor 
rate is $60 per work hour. Based on these figures, the total cost 
impact of the AD on U.S. operators is estimated to be $39,600, or 
$3,300 per airplane.
    The total cost impact figure discussed above is based on 
assumptions that no operator has yet accomplished any of the 
requirements of this AD action, and that no operator would accomplish 
those actions in the future if this AD were not adopted.
    The regulations adopted herein will not have substantial direct 
effects on the States, on the relationship between the national 
government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, in 
accordance with Executive Order 12612, it is determined that this final 
rule does not have sufficient federalism implications to warrant the 
preparation of a Federalism Assessment.
    For the reasons discussed above, I certify that this action (1) Is 
not a ``significant regulatory action'' under Executive Order 12866; 
(2) is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
significant economic impact, positive or negative, on a substantial 
number of small entities under the criteria of the Regulatory 
Flexibility Act. A final evaluation has been prepared for this action 
and it is contained in the Rules Docket. A copy of it may be obtained 
from the Rules Docket at the location provided under the caption 
ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration amends part 39 of 
the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. App. 1354(a), 1421 and 1423; 49 U.S.C. 
106(g); and 14 CFR 11.89.


Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding the following new 
airworthiness directive:

95-03-05  Fokker: Amendment 39-9142. Docket 94-NM-118-AD.

    Applicability: Model F28 Mark 0100 series airplanes; as listed 
in Fokker Service Bulletin SBF100-57-018, dated September 23, 1993; 
certificated in any category.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must use the authority 
provided in paragraph (b) to request approval from the FAA. This 
approval may address either no action, if the current configuration 
eliminates the unsafe condition; or different actions necessary to 
address the unsafe condition described in this AD. Such a request 
should include an assessment of the effect of the changed 
configuration on the unsafe condition addressed by this AD. In no 
case does the presence of any modification, alteration, or repair 
remove any airplane from the applicability of this AD.

    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent reduced structural integrity of the wing, accomplish 
the following:
    (a) Prior to the accumulation of 16,000 total flight cycles or 
within 3 months after the effective date of this AD, whichever 
occurs later, perform a one-time high-frequency eddy current 
inspection to detect cracks in the cleats at the left- and right-
hand rib station 8200 of the wing, in accordance with Fokker Service 
Bulletin SBF100-57-018, dated September 23, 1993. If any cracked 
cleat is detected, prior to further flight, replace it with a new 
cleat, in accordance with the service bulletin.
    (b) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, Standardization Branch, ANM-113, 
FAA, Transport Airplane Directorate. Operators shall submit their 
requests through an appropriate FAA Principal Maintenance Inspector, 
who may add comments and then [[Page 8929]] send it to the Manager, 
Standardization Branch, ANM-113.

    Note 2: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the Standardization Branch, ANM-113.

    (c) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the airplane to a location where 
the requirements of this AD can be accomplished.
    (d) The inspection and replacement shall be done in accordance 
with Fokker Service Bulletin SBF100-57-018, dated September 23, 
1993. This incorporation by reference was approved by the Director 
of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR 
part 51. Copies may be obtained from Fokker Aircraft USA, Inc., 1199 
North Fairfax Street, Alexandria, Virginia 22314. Copies may be 
inspected at the FAA, Transport Airplane Directorate, 1601 Lind 
Avenue, SW., Renton, Washington; or at the Office of the Federal 
Register, 800 North Capitol Street, NW., suite 700, Washington, DC.
    (e) This amendment becomes effective on March 20, 1995.

    Issued in Renton, Washington, on February 3, 1995.
S.R. Miller,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 95-3247 Filed 2-15-95; 8:45 am]
BILLING CODE 4910-13-U

The complete text was extracted from the official GovInfo HTML edition for this publication. Acquired 2026-10-09T05:17:16.567571+00:00. Text extraction preserves the recorded source wording; it does not determine current requirements.

Open the captured official edition

Source SHA-256

8d9bea260daa1198766a8884d4ed0ffc9f590d1f90f29f9a1d38ab22432124fa

Text SHA-256

16df842658113fb05de9fba2775ff3f82d18b74e3a58313ac1e94540f8cb2cbe