Airworthiness Directives; Airbus Model A310 Series Airplanes

[Federal Register Volume 62, Number 79 (Thursday, April 24, 1997)]
[Rules and Regulations]
[Pages 19919-19920]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 97-10319]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 96-NM-169-AD; Amendment 39-9999; AD 97-09-03]
RIN 2120-AA64


Airworthiness Directives; Airbus Model A310 Series Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD), 
applicable to certain Airbus Model A310 series airplanes, that requires 
modification of the wiring for certain hydraulic fire shutoff valves to 
the right engine to prevent chafing. This amendment is prompted by 
reports indicating that a circuit breaker to wiring in the right engine 
had tripped on two airplanes, the cause of which has been attributed to 
chafing of the associated wire bundle. The actions specified by this AD 
are intended to prevent this wiring from chafing which, if not 
corrected, could lead to short circuiting of this wiring and the 
consequent inability to close the hydraulic fire shutoff valves to the 
right engine in the event of fire.

DATES: Effective May 29, 1997.
    The incorporation by reference of certain publications listed in 
the regulations is approved by the Director

[[Page 19920]]

of the Federal Register as of May 29, 1997.

ADDRESSES: The service information referenced in this AD may be 
obtained from Airbus Industrie, 1 Rond Point Maurice Bellonte, 31707 
Blagnac Cedex, France. This information may be examined at the Federal 
Aviation Administration (FAA), Transport Airplane Directorate, Rules 
Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of 
the Federal Register, 800 North Capitol Street, NW., suite 700, 
Washington, DC.

FOR FURTHER INFORMATION CONTACT: Charles Huber, Aerospace Engineer, 
Standardization Branch, ANM-113, FAA, Transport Airplane Directorate, 
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (206) 
227-2589; fax (206) 227-1149.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal 
Aviation Regulations (14 CFR part 39) to include an airworthiness 
directive (AD) that is applicable to certain Airbus Model A310 series 
airplanes was published in the Federal Register on January 27, 1997 (62 
FR 3836). That action proposed to require modification of the wiring 
for certain hydraulic fire shutoff valves to the right engine to 
prevent chafing.
    Interested persons have been afforded an opportunity to participate 
in the making of this amendment. Due consideration has been given to 
the single comment received.
    The commenter supports the proposed rule.

Conclusion

    After careful review of the available data, including the comment 
noted above, the FAA has determined that air safety and the public 
interest require the adoption of the rule as proposed.

Cost Impact

    The FAA estimates that 20 Airbus Model A310 series airplanes of 
U.S. registry will be affected by this AD, that it will take 
approximately 4 work hours per airplane to accomplish the required 
actions, and that the average labor rate is $60 per work hour. Required 
parts will be provided by the manufacturer at no cost to operators. 
Based on these figures, the cost impact of the AD on U.S. operators is 
estimated to be $4,800, or $240 per airplane.
    The cost impact figure discussed above is based on assumptions that 
no operator has yet accomplished any of the requirements of this AD 
action, and that no operator would accomplish those actions in the 
future if this AD were not adopted.

Regulatory Impact

    The regulations adopted herein will not have substantial direct 
effects on the States, on the relationship between the national 
government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, in 
accordance with Executive Order 12612, it is determined that this final 
rule does not have sufficient federalism implications to warrant the 
preparation of a Federalism Assessment.
    For the reasons discussed above, I certify that this action (1) Is 
not a ``significant regulatory action'' under Executive Order 12866; 
(2) is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
significant economic impact, positive or negative, on a substantial 
number of small entities under the criteria of the Regulatory 
Flexibility Act. A final evaluation has been prepared for this action 
and it is contained in the Rules Docket. A copy of it may be obtained 
from the Rules Docket at the location provided under the caption 
ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration amends part 39 of 
the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding the following new 
airworthiness directive:

97-09-03 Airbus Industrie: Amendment 39-9999. Docket 96-NM-169-AD.

    Applicability: Model A310 series airplanes as listed in Airbus 
Service Bulletin A310-24-2065, dated November 30, 1995, and Revision 
1, dated April 19, 1996; certificated in any category.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
otherwise modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an 
alternative method of compliance in accordance with paragraph (b) of 
this AD. The request should include an assessment of the effect of 
the modification, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.

    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent chafing of wire bundles for the hydraulic fire 
shutoff valves to the right engine, which could lead to short 
circuiting of this wiring and the consequent inability to close 
these valves in the event of fire, accomplish the following:
    (a) Within 60 days after the effective date of this AD, modify 
the wiring for the hydraulic fire shutoff valves in wire bundles 
626VB and 628VB, and modify wire bundle 632VB, in accordance with 
Airbus Service Bulletin A310-24-2065, dated November 30, 1995, or 
Revision 1, dated April 19, 1996, as applicable.
    (b) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, Standardization Branch, ANM-113, 
FAA, Transport Airplane Directorate. Operators shall submit their 
requests through an appropriate FAA Principal Maintenance Inspector, 
who may add comments and then send it to the Manager, 
Standardization Branch, ANM-113.

    Note 2: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the Standardization Branch, ANM-113.

    (c) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the airplane to a location where 
the requirements of this AD can be accomplished.
    (d) The modifications shall be done in accordance with Airbus 
Service Bulletin A310-24-2065, dated November 30, 1995, or Airbus 
Service Bulletin A310-24-2065, Revision 1, dated April 19, 1996, as 
applicable. This incorporation by reference was approved by the 
Director of the Federal Register in accordance with 5 U.S.C. 552(a) 
and 1 CFR part 51. Copies may be obtained from Airbus Industrie, 1 
Rond Point Maurice Bellonte, 31707 Blagnac Cedex, France. Copies may 
be inspected at the FAA, Transport Airplane Directorate, 1601 Lind 
Avenue, SW., Renton, Washington; or at the Office of the Federal 
Register, 800 North Capitol Street, NW., suite 700, Washington, DC.
    (e) This amendment becomes effective on May 29, 1997.

    Issued in Renton, Washington, on April 16, 1997.
Darrell M. Pederson,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 97-10319 Filed 4-23-97; 8:45 am]
BILLING CODE 4910-13-U

The complete text was extracted from the official GovInfo HTML edition for this publication. Acquired 2026-10-09T05:12:25.074698+00:00. Text extraction preserves the recorded source wording; it does not determine current requirements.

Open the captured official edition

Source SHA-256

55105a205c367de868848c10beb3a2ffd95394e390b7ef9546820e737c7f255a

Text SHA-256

90a768a9fdfe307c86c0e36910f3b3c3bc93b9ef3fbd78d4b6d6d9ab6c4b468f