Airworthiness Directives; British Aerospace (Jetstream) Model 4101 Airplanes

[Federal Register Volume 63, Number 87 (Wednesday, May 6, 1998)]
[Rules and Regulations]
[Pages 24915-24916]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 98-11809]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 97-NM-199-AD; Amendment 39-10513; AD 98-10-02]
RIN 2120-AA64


Airworthiness Directives; British Aerospace (Jetstream) Model 
4101 Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD), 
applicable to certain British Aerospace (Jetstream) Model 4101 
airplanes, that requires replacement of certain wheel tie bolts with 
new bolts; and placing a life limit on these wheel tie bolts. This 
amendment is prompted by issuance of mandatory continuing airworthiness 
information by a foreign civil airworthiness authority. The actions 
specified by this AD are intended to prevent metal fatigue failure of 
the wheel tie bolts, which could result in a tire burst or loss of the 
main wheel/tire assembly, and consequent reduced controllability of the 
airplane.

DATES: Effective June 10, 1998.
    The incorporation by reference of certain publications listed in 
the regulations is approved by the Director of the Federal Register as 
of June 10, 1998.


[[Page 24916]]


ADDRESSES: The service information referenced in this AD may be 
obtained from AI(R) American Support, Inc., 13850 Mclearen Road, 
Herndon, Virginia 20171. This information may be examined at the 
Federal Aviation Administration (FAA), Transport Airplane Directorate, 
Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the 
Office of the Federal Register, 800 North Capitol Street, NW., suite 
700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: Norman B. Martenson, Manager, 
International Branch, ANM-116, FAA, Transport Airplane Directorate, 
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 
227-2110; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal 
Aviation Regulations (14 CFR part 39) to include an airworthiness 
directive (AD) that is applicable to certain British Aerospace 
(Jetstream) Model 4101 airplanes was published in the Federal Register 
on February 23, 1998 (63 FR 8881). That action proposed to require 
replacement of certain wheel tie bolts with new bolts; and placing a 
life limit on these wheel tie bolts.

Comments

    Interested persons have been afforded an opportunity to participate 
in the making of this amendment. No comments were submitted in response 
to the proposal or the FAA's determination of the cost to the public.

Conclusion

    The FAA has determined that air safety and the public interest 
require the adoption of the rule as proposed.

Interim Action

    This is considered to be interim action until final action is 
identified, at which time the FAA may consider further rulemaking.

Cost Impact

    The FAA estimates that 57 airplanes of U.S. registry will be 
affected by this AD; however, wheel tie bolts must be removed and 
reinstalled during each tire change, therefore no additional work hours 
would be required as a result of this AD. Required parts will be 
supplied by the manufacturer at no charge. Based on this information, 
the cost impact of the AD on U.S. operators is estimated to be 
negligible.

Regulatory Impact

    The regulations adopted herein will not have substantial direct 
effects on the States, on the relationship between the national 
government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, in 
accordance with Executive Order 12612, it is determined that this final 
rule does not have sufficient federalism implications to warrant the 
preparation of a Federalism Assessment.
    For the reasons discussed above, I certify that this action (1) is 
not a ``significant regulatory action'' under Executive Order 12866; 
(2) is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
significant economic impact, positive or negative, on a substantial 
number of small entities under the criteria of the Regulatory 
Flexibility Act. A final evaluation has been prepared for this action 
and it is contained in the Rules Docket. A copy of it may be obtained 
from the Rules Docket at the location provided under the caption 
ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration amends part 39 of 
the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding the following new 
airworthiness directive:

98-10-02  British Aerospace Regional Aircraft [Formerly Jetstream 
Aircraft Limited; British Aerospace (Commercial Aircraft) Limited]: 
Amendment 39-10513. Docket 97-NM-199-AD.

    Applicability: Jetstream Model 4101 airplanes equipped with main 
wheels having part number (P/N) AHA1837, certificated in any 
category.

    Note 1. This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an 
alternative method of compliance in accordance with paragraph (b) of 
this AD. The request should include an assessment of the effect of 
the modification, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.

    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent metal fatigue failure of the wheel tie bolts, which 
could result in a tire burst or loss of the main wheel/tire 
assembly, and consequent reduced controllability of the airplane, 
accomplish the following:
    (a) At the next tire change after the effective date of this AD, 
remove main wheel tie bolts having P/N BAC-B30M516 (DSR4528-1216), 
and replace them with new tie bolts in accordance with Jetstream 
Service Bulletin J41-32-058, dated May 9, 1997. Repeat this 
replacement thereafter at every fifth tire change.
    (b) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, International Branch, ANM-116, FAA, 
Transport Airplane Directorate. Operators shall submit their 
requests through an appropriate FAA Principal Maintenance Inspector, 
who may add comments and then send it to the Manager, International 
Branch, ANM-116.

    Note 2: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the International Branch, ANM-116.

    (c) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the airplane to a location where 
the requirements of this AD can be accomplished.
    (d) The actions shall be done in accordance with Jetstream 
Service Bulletin J41-32-058, dated May 9, 1997. This incorporation 
by reference was approved by the Director of the Federal Register in 
accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be 
obtained from AI(R) American Support, Inc., 13850 Mclearen Road, 
Herndon, Virginia 20171. Copies may be inspected at the FAA, 
Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, 
Washington; or at the Office of the Federal Register, 800 North 
Capitol Street, NW., suite 700, Washington, DC.

    Note 3: The subject of this AD is addressed in CAA airworthiness 
directive 002-05-97.

    (e) This amendment becomes effective on June 10, 1998.

    Issued in Renton, Washington, on April 28, 1998.
John J. Hickey,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 98-11809 Filed 5-5-98; 8:45 am]
BILLING CODE 4910-13-U

The complete text was extracted from the official GovInfo HTML edition for this publication. Acquired 2026-10-09T05:02:56.334728+00:00. Text extraction preserves the recorded source wording; it does not determine current requirements.

Open the captured official edition

Source SHA-256

591ef003bb16ebbfb25578507212d1bb2ac86c1bb60d1a074fcccf36fbdcaeca

Text SHA-256

e2ef711d83adca2d95c90db43116a4f4033578be0d1df7ffbd42da1b7d1fca27