Airworthiness Directives; Saab Model SAAB 340B and SAAB 2000 Series Airplanes

[Federal Register Volume 63, Number 106 (Wednesday, June 3, 1998)]
[Rules and Regulations]
[Pages 30117-30118]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 98-14221]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 97-NM-134-AD; Amendment 39-10551; AD 98-11-26]
RIN 2120-AA64


Airworthiness Directives; Saab Model SAAB 340B and SAAB 2000 
Series Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD), 
applicable to certain Saab Model SAAB 340B and SAAB 2000 series 
airplanes, that requires modification of the check valves of the 
airfoil de-icing system, or replacement of the check valves with 
improved valves. This amendment is prompted by issuance of mandatory 
continuing airworthiness information by a foreign civil airworthiness 
authority. The actions specified by this AD are intended to prevent 
failure of the check valves, which could result in loss of airfoil de-
icing capability during single engine operation, and consequent reduced 
controllability of the airplane.

DATES: Effective July 8, 1998.
    The incorporation by reference of certain publications listed in 
the regulations is approved by the Director of the Federal Register as 
of July 8, 1998.

ADDRESSES: The service information referenced in this AD may be 
obtained from Saab Aircraft AB, SAAB Aircraft Product Support, S-
581.88, Linkoping, Sweden. This information may be examined at the 
Federal Aviation Administration (FAA), Transport Airplane Directorate, 
Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the 
Office of the Federal Register, 800 North Capitol Street, NW., suite 
700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: Norman B. Martenson, Manager, 
International Branch, ANM-116, FAA, Transport Airplane Directorate, 
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 
227-2110; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal 
Aviation Regulations (14 CFR part 39) to include an airworthiness 
directive (AD) that is applicable to certain Saab Model SAAB 340B and 
SAAB 2000 series airplanes was published in the Federal Register on 
April 1, 1998 (63 FR 15797). That action proposed to require 
modification of the check valves of the airfoil de-icing system, or 
replacement of the check valves with improved valves.

Comments

    Interested persons have been afforded an opportunity to participate 
in the making of this amendment. No comments were submitted in response 
to the proposal or the FAA's determination of the cost to the public.

Conclusion

    The FAA has determined that air safety and the public interest 
require the adoption of the rule as proposed.

Cost Impact

    The FAA estimates that 125 Model SAAB 340B and SAAB 2000 series 
airplanes of U.S. registry will be affected by this AD, that it will 
take approximately 4 work hours per airplane to accomplish the required 
actions, and that the average labor rate is $60 per work hour. Required 
parts will be provided by the manufacturer at no cost to the operators. 
Based on these figures, the cost impact of the AD on U.S. operators is 
estimated to be $30,000, or $240 per airplane.
    The cost impact figure discussed above is based on assumptions that 
no operator has yet accomplished any of the requirements of this AD 
action, and that no operator would accomplish those actions in the 
future if this AD were not adopted.

Regulatory Impact

    The regulations adopted herein will not have substantial direct 
effects on the States, on the relationship between the national 
government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, in 
accordance with Executive Order 12612, it is determined that this final 
rule does not have sufficient federalism implications to warrant the 
preparation of a Federalism Assessment.
    For the reasons discussed above, I certify that this action (1) is 
not a ``significant regulatory action'' under Executive Order 12866; 
(2) is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
significant economic impact, positive or negative, on a substantial 
number of small entities under the criteria of the Regulatory 
Flexibility Act. A final evaluation has been prepared for this action 
and it is contained in the Rules Docket. A copy of it may be obtained 
from the Rules Docket at the location provided under the caption 
ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration amends part 39 of 
the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding the following new 
airworthiness directive:

98-11-26 SAAB AIRCRAFT AB: Amendment 39-10551. Docket 97-NM-134-AD.

    Applicability: Model SAAB 340B series airplanes, serial numbers 
240 through 430 inclusive; Model SAAB 2000 series airplanes, serial 
numbers 002 through 050 inclusive, and 052; certificated in any 
category.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an 
alternative method of compliance in accordance with paragraph (b) of 
this AD. The request should include an assessment of the effect of 
the modification, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.

    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent failure of the check valves, which could result in 
loss of airfoil de-icing

[[Page 30118]]

capability during single engine operation, and consequent reduced 
controllability of the airplane, accomplish the following:
    (a) Within 5 months after the effective date of this AD, modify 
the left- and right-hand check valves of the airfoil de-icing 
system, or replace the check valves with improved valves, in 
accordance with Saab Service Bulletin 340-30-080, dated November 21, 
1997 (for Model SAAB 340B series airplanes), or Saab Service 
Bulletin 2000-30-012, dated November 21, 1997 (for Model SAAB 2000 
series airplanes), as applicable.
    (b) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, International Branch, ANM-116, FAA, 
Transport Airplane Directorate. Operators shall submit their 
requests through an appropriate FAA Principal Maintenance Inspector, 
who may add comments and then send it to the Manager, International 
Branch, ANM-116.

    Note 2: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the International Branch, ANM-116.

    (c) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the airplane to a location where 
the requirements of this AD can be accomplished.
    (d) The actions shall be done in accordance with Saab Service 
Bulletin 340-30-080, dated November 21, 1997, or Saab Service 
Bulletin 2000-30-012, dated November 21, 1997, as applicable. This 
incorporation by reference was approved by the Director of the 
Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 
51. Copies may be obtained from Saab Aircraft AB, SAAB Aircraft 
Product Support, S-581.88, Linkoping, Sweden. Copies may be 
inspected at the FAA, Transport Airplane Directorate, 1601 Lind 
Avenue, SW., Renton, Washington; or at the Office of the Federal 
Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

    Note 3: The subject of this AD is addressed in Swedish 
airworthiness directive SAD No. 1-120, dated November 24, 1997.

    (e) This amendment becomes effective on July 8, 1998.

    Issued in Renton, Washington, on May 22, 1998.
Darrell M. Pederson,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 98-14221 Filed 6-2-98; 8:45 am]
BILLING CODE 4910-13-U

The complete text was extracted from the official GovInfo HTML edition for this publication. Acquired 2026-10-09T05:02:14.051956+00:00. Text extraction preserves the recorded source wording; it does not determine current requirements.

Open the captured official edition

Source SHA-256

9ea964afd3714d24c2c97e1098e8dd849fb50e007104e677d80670dbc7b97b41

Text SHA-256

a14a457248cc0d4a4e4f7cbf04c2c8e02911dfb492f4a9063bc4925507de4194