Airworthiness Directives; AERMACCHI S.p.A. S.205 Series and Models S.208 and S.208A Airplanes

[Federal Register Volume 63, Number 109 (Monday, June 8, 1998)]
[Rules and Regulations]
[Pages 31107-31108]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 98-15084]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 97-CE-146-AD; Amendment 39-10570; AD 98-12-14]
RIN 2120-AA64


Airworthiness Directives; AERMACCHI S.p.A. S.205 Series and 
Models S.208 and S.208A Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD) that 
applies to certain AERMACCHI S.p.A. (AERMACCHI) S.205 series and Models 
S.208 and S.208A airplanes. This AD requires inspecting the flap cable 
pulley bracket for correct alignment and correcting any misalignment; 
inspecting the flap control cable for wear (nicks, cuts, frays, etc.), 
and replacing the flap control pulley bracket and flap control cable if 
worn. This AD is the result of mandatory continuing airworthiness 
information (MCAI) issued by the airworthiness authority for Italy. The 
actions specified by this AD are intended to prevent flap control 
failure, which could result in loss of control of the airplane.

DATES: Effective July 18, 1998.
    The incorporation by reference of certain publications listed in 
the regulations is approved by the Director of the Federal Register as 
of July 18, 1998.

ADDRESSES: Service information that applies to this AD may be obtained 
from SIAI Marchetti, Product Support, Via Indipendenza 2, 21018 Sesto 
Calende (VA), Italy; telephone: +39-331-929117; facsimile: +39-331-
922525. This information may also be examined at the Federal Aviation 
Administration (FAA), Central Region, Office of the Regional Counsel, 
Attention: Rules Docket No. 97-CE-146-AD, Room 1558, 601 E. 12th 
Street, Kansas City, Missouri 64106; or at the Office of the Federal 
Register, 800 North Capitol Street, NW, suite 700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: Mr. David O. Keenan, Project Officer, 
FAA, Small Airplane Directorate, Aircraft Certification Service, 1201 
Walnut, suite 900, Kansas City, Missouri 64106; telephone: (816) 426-
6934; facsimile: (816) 426-2169.

SUPPLEMENTARY INFORMATION:

Events Leading to the Issuance of This AD

    A proposal to amend part 39 of the Federal Aviation Regulations (14 
CFR part 39) to include an AD that would apply to certain AERMACCHI 
S.205 series and Models S.208 and S.208A airplanes was published in the 
Federal Register as a notice of proposed rulemaking (NPRM) on March 13, 
1998 (63 FR 12418). The NPRM proposed to require: inspecting the flap 
control pulley bracket for alignment; correcting any misalignment; 
inspecting the flap control pulley cable for wear; and, replacing the 
bracket and cable if worn. Accomplishment of the proposed actions as 
specified in the NPRM would be in accordance with SIAI Marchetti 
Service Bulletin No. 205B60, dated July 24, 1995.
    The NPRM was the result of mandatory continuing airworthiness 
information (MCAI) issued by the airworthiness authority for Italy.
    Interested persons have been afforded an opportunity to participate 
in the making of this amendment. No comments were received on the 
proposed rule or the FAA's determination of the cost to the public.

The FAA's Determination

    After careful review of all available information related to the 
subject presented above, the FAA has determined that air safety and the 
public interest require the adoption of the rule as proposed except for 
minor

[[Page 31108]]

editorial corrections. The FAA has determined that these minor 
corrections will not change the meaning of the AD and will not add any 
additional burden upon the public than was already proposed.

Cost Impact

    The FAA estimates that 70 airplanes in the U.S. registry will be 
affected by this AD, that it will take approximately 4 workhours per 
airplane to accomplish this action, and that the average labor rate is 
approximately $60 an hour. Parts cost approximately $150 per airplane. 
Based on these figures, the total cost impact of this AD on U.S. 
operators is estimated to be $27,300, or $390 per airplane.

Regulatory Impact

    The regulations adopted herein will not have substantial direct 
effects on the States, on the relationship between the national 
government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, in 
accordance with Executive Order 12612, it is determined that this final 
rule does not have sufficient federalism implications to warrant the 
preparation of a Federalism Assessment.
    For the reasons discussed above, I certify that this action (1) is 
not a ``significant regulatory action'' under Executive Order 12866; 
(2) is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
significant economic impact, positive or negative, on a substantial 
number of small entities under the criteria of the Regulatory 
Flexibility Act. A copy of the final evaluation prepared for this 
action is contained in the Rules Docket. A copy of it may be obtained 
by contacting the Rules Docket at the location provided under the 
caption ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration amends part 39 of 
the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding a new airworthiness directive 
(AD) to read as follows:

98-12-14  Aermacchi S.P.A.: Amendment 39-10570; Docket No. 97-CE-
146-AD.

    Applicability: Models S.205-18/F, S.205-18/R, S.205-20/F, S.205-
20/R, S.205-22/R, S.208, and S.208A airplanes, all serial numbers, 
certificated in any category.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an 
alternative method of compliance in accordance with paragraph (d) of 
this AD. The request should include an assessment of the effect of 
the modification, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.

    Compliance: Required within the next 100 hours time-in-service 
(TIS) after the effective date of this AD, unless already 
accomplished.
    To prevent flap control failure which could result in loss of 
control of the airplane, accomplish the following:
    (a) Inspect the flap cable pulley bracket for correct alignment, 
and if the flap cable pulley bracket is misaligned, prior to further 
flight, correct any misalignment of the pulley bracket in accordance 
with the Instructions section of SIAI Marchetti Service Bulletin No. 
205B60, dated July 24, 1995.
    (b) Inspect the flap control cable for wear (cuts, nicks, frays, 
etc.), and if wear is found, prior to further flight, replace the 
flap control cable and flap cable pulley bracket in accordance with 
the Instructions section of SIAI Marchetti Service Bulletin No. 
205B60, dated July 24, 1995.
    (c) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the airplane to a location where 
the requirements of this AD can be accomplished.
    (d) An alternative method of compliance or adjustment of the 
compliance time that provides an equivalent level of safety may be 
approved by the Manager, Small Airplane Directorate, 1201 Walnut, 
suite 900, Kansas City, Missouri 64106. The request shall be 
forwarded through an appropriate FAA Maintenance Inspector, who may 
add comments and then send it to the Manager, Small Airplane 
Directorate.

    Note 2: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the Small Airplane Directorate.

    (e) Questions or technical information related to SIAI Marchetti 
Mandatory Service Bulletin No. 205B60, dated July 24, 1995, should 
be directed to SIAI Marchetti, Product Support, Via Indipendenza 2, 
21018 Sesto Calende (VA), Italy; telephone: +39-331-929117; 
facsimile: +39-331-922525. This service information may be examined 
at the FAA, Central Region, Office of the Regional Counsel, Room 
1558, 601 E. 12th Street, Kansas City, Missouri 64106.
    (f) The inspections and replacements required by this AD shall 
be done in accordance with SIAI Marchetti Mandatory Service Bulletin 
No. 205B60, dated July 24, 1995. This incorporation by reference was 
approved by the Director of the Federal Register in accordance with 
5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from SIAI 
Marchetti, Product Support, Via Indipendenza 2, 21018 Sesto Calende 
(VA), Italy. Copies may be inspected at the FAA, Central Region, 
Office of the Regional Counsel, Room 1558, 601 E. 12th Street, 
Kansas City, Missouri, or at the Office of the Federal Register, 800 
North Capitol Street, NW, suite 700, Washington, DC.

    Note 3: The subject of this AD is addressed in Italian AD 95-
237, dated August 29, 1995.

    (g) This amendment becomes effective on July 18, 1998.

    Issued in Kansas City, Missouri, on May 29, 1998.
Michael Gallagher,
Manager, Small Airplane Directorate, Aircraft Certification Service.
[FR Doc. 98-15084 Filed 6-5-98; 8:45 am]
BILLING CODE 4910-13-U

The complete text was extracted from the official GovInfo HTML edition for this publication. Acquired 2026-10-09T05:02:02.045776+00:00. Text extraction preserves the recorded source wording; it does not determine current requirements.

Open the captured official edition

Source SHA-256

a9e3bd1b9e2bf4c6c3981f399d9b5caaa40a3b9557913c123d176acda42309f0

Text SHA-256

535dc5c8b34f9a52e996abf14f4579a233d7599c096511a5abb172973b0e981c