Back to publication catalog

Published 1998-02-23 · Federal Register document 98-4248

Airworthiness Directives; Grumman Model TS-2A Series Airplanes

Publication summary

This amendment adopts a new airworthiness directive (AD), applicable to all Grumman Model TS-2A series airplanes, that requires revising the Airplane Flight Manual (AFM) to modify the limitation that prohibits positioning the power levers below the flight idle stop during flight, and to add a statement of the consequences of such positioning of the power levers. This amendment is prompted by incidents and accidents involving airplanes equipped with turboprop engines in which the ground propeller beta range was used improperly during flight. The actions specified by this AD are intended to prevent loss of airplane controllability, or engine overspeed and consequent loss of engine power, caused by the power levers being positioned below the flight idle stop when the airplane is in flight.

Why this record is shown

Source: Federal Register annual FAA metadata. Acquired 2026-09-03T22:22:53.985165+00:00. The title, summary and date are source facts.

Source revision
federal_register_ad_metadata_1998-f5c1cf5c93c99179
Source row
results[83]
Raw source SHA-256
f5c1cf5c93c99179023030016db80652e7593139090148c64a6fd533918aa991

Final-rule publication

Recorded publication clauses

AD identifier printed in this edition
98-04-42
Effective date printed in this edition
1998-03-30

Some source clauses remain unstructured. Read the complete publication for conditions that have not been interpreted here.

Read 2 complete recorded clauses
Applicability wording · Applicability
    Applicability: All Model TS-2A series airplanes, certificated in 
any category.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an 
alternative method of compliance in accordance with paragraph (b) of 
this AD. The request should include an assessment of the effect of 
the modification, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.

Exact source excerpt. Text positions 5529–6361, end exclusive, in the original decoded publication. SHA-256: 8358381c0af23e7559395a3d9fc7e9c35bc6eafffb4613478659567b4177c0da

Compliance and requirements
    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent loss of airplane controllability, or engine overspeed 
and consequent loss of engine power, caused by the power levers 
being positioned below the flight idle stop while the airplane is in 
flight, accomplish the following:
    (a) Within 30 days after the effective date of this AD, revise 
the Limitations Section of the FAA-approved Airplane Flight Manual 
(AFM) to include the following statements. This action may be 
accomplished by inserting a copy of this AD into the AFM.
    Positioning of power levers below the flight idle stop while the 
airplane is in flight is prohibited. Such positioning may lead to 
loss of airplane control or may result in an overspeed condition and 
consequent loss of engine power.
    (b) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, Los Angeles Aircraft Certification 
Office (ACO),

[[Page 8850]]

FAA, Transport Airplane Directorate. Operators shall submit their 
requests through an appropriate FAA Principal Operations Inspector, 
who may add comments and then send it to the Manager, Los Angeles 
ACO.

    Note 2: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the Los Angeles ACO.

    (c) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the airplane to a location where 
the requirements of this AD can be accomplished.
    (d) This amendment becomes effective on March 30, 1998.

Exact source excerpt. Text positions 6361–8083, end exclusive, in the original decoded publication. SHA-256: 7a14160c72b73d00e5acc32528c29d909e7c81027d677aa0782a9e63a5754246

No replacement link has been established from this edition. The complete historical rule chain and current legal effect remain unknown.

Find all recorded historical references to AD 98-04-42 · 0 printed reference observations in this pinned collection.

These are observations from one dated publication. Current legal status is unknown; aircraft applicability, installed configuration, compliance and burden require separate evidence. Missing or unparsed conditions remain unknown.

Why these observations are shown

They were extracted offline from the same immutable official HTML source as the complete recorded text. The dated source wording, original text coordinates and exact quote digests are retained. PDF/text agreement and current regulatory effect have not been qualified.

Observation revision: whole-ad-publication-clause-observations-1.0.1. Text SHA-256: a901732f4027d92f7d090986d5a4be3e8eb5383f8d09d1fbeb1bbaeb895230a9. Source manifest: ead3cdf1586e41beac4a01305cfbecf99563060747369b9482d2bdfa20567cd6.

Official source · 1998-02-23

Publication text

This is the complete recorded text of this dated publication.

Current legal effect is unknown. Aircraft applicability, installed configuration and compliance require separate evidence. PDF/text agreement has not been evaluated.

Read the complete official publication text
[Federal Register Volume 63, Number 35 (Monday, February 23, 1998)]
[Rules and Regulations]
[Pages 8849-8850]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 98-4248]



[[Page 8849]]

-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 97-NM-75-AD; Amendment 39-10353; AD 98-04-42]
RIN 2120-AA64


Airworthiness Directives; Grumman Model TS-2A Series Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD), 
applicable to all Grumman Model TS-2A series airplanes, that requires 
revising the Airplane Flight Manual (AFM) to modify the limitation that 
prohibits positioning the power levers below the flight idle stop 
during flight, and to add a statement of the consequences of such 
positioning of the power levers. This amendment is prompted by 
incidents and accidents involving airplanes equipped with turboprop 
engines in which the ground propeller beta range was used improperly 
during flight. The actions specified by this AD are intended to prevent 
loss of airplane controllability, or engine overspeed and consequent 
loss of engine power, caused by the power levers being positioned below 
the flight idle stop when the airplane is in flight.

EFFECTIVE DATE: March 30, 1998.

ADDRESSES: Information pertaining to this rulemaking action may be 
examined at the Federal Aviation Administration (FAA), Transport 
Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, 
Washington.

FOR FURTHER INFORMATION CONTACT: Frank Hoerman, Aerospace Engineer, 
Flight Test Branch, ANM-160L, FAA, Transport Airplane Directorate, Los 
Angeles Aircraft Certification Office, 3960 Paramount Boulevard, 
Lakewood, California 90712; telephone (562) 527-5371; fax (562) 625-
5210.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal 
Aviation Regulations (14 CFR part 39) to include an airworthiness 
directive (AD) that is applicable to all Grumman Model TS-2A series 
airplanes was published in the Federal Register on December 9, 1997 (62 
FR 64780). That action proposed to require revising the Limitations 
Section of the Airplane Flight Manual (AFM) to modify the limitation 
that prohibits positioning of the power levers below the flight idle 
stop while the airplane is in flight, and adds a statement of the 
consequences of positioning the power levers below the flight idle stop 
while the airplane is in flight.

Comments

    Interested persons have been afforded an opportunity to participate 
in the making of this amendment. No comments were submitted in response 
to the proposal or the FAA's determination of the cost to the public.

Conclusion

    The FAA has determined that air safety and the public interest 
require the adoption of the rule as proposed.

Interim Action

    This is considered interim action until final action is identified, 
at which time the FAA may consider further rulemaking.

Cost Impact

    The FAA estimates that 1 airplane of U.S. registry will be affected 
by this AD, that it will take approximately 1 work hour per airplane to 
accomplish the required actions, and that the average labor rate is $60 
per work hour. Based on these figures, the cost impact of the AD on the 
single U.S. operator is estimated to be $60.
    The cost impact figure discussed above is based on assumptions that 
no operator has yet accomplished any of the requirements of this AD 
action, and that no operator would accomplish those actions in the 
future if this AD were not adopted.

Regulatory Impact

    The regulations adopted herein will not have substantial direct 
effects on the States, on the relationship between the national 
government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, in 
accordance with Executive Order 12612, it is determined that this final 
rule does not have sufficient federalism implications to warrant the 
preparation of a Federalism Assessment.
    For the reasons discussed above, I certify that this action (1) is 
not a ``significant regulatory action'' under Executive Order 12866; 
(2) is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
significant economic impact, positive or negative, on a substantial 
number of small entities under the criteria of the Regulatory 
Flexibility Act. A final evaluation has been prepared for this action 
and it is contained in the Rules Docket. A copy of it may be obtained 
from the Rules Docket at the location provided under the caption 
ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Safety.

Adoption of the Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration amends part 39 of 
the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding the following new 
airworthiness directive:

98-04-42  Grumman: Amendment 39-10353. Docket 97-NM-75-AD.

    Applicability: All Model TS-2A series airplanes, certificated in 
any category.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an 
alternative method of compliance in accordance with paragraph (b) of 
this AD. The request should include an assessment of the effect of 
the modification, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.

    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent loss of airplane controllability, or engine overspeed 
and consequent loss of engine power, caused by the power levers 
being positioned below the flight idle stop while the airplane is in 
flight, accomplish the following:
    (a) Within 30 days after the effective date of this AD, revise 
the Limitations Section of the FAA-approved Airplane Flight Manual 
(AFM) to include the following statements. This action may be 
accomplished by inserting a copy of this AD into the AFM.
    Positioning of power levers below the flight idle stop while the 
airplane is in flight is prohibited. Such positioning may lead to 
loss of airplane control or may result in an overspeed condition and 
consequent loss of engine power.
    (b) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, Los Angeles Aircraft Certification 
Office (ACO),

[[Page 8850]]

FAA, Transport Airplane Directorate. Operators shall submit their 
requests through an appropriate FAA Principal Operations Inspector, 
who may add comments and then send it to the Manager, Los Angeles 
ACO.

    Note 2: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the Los Angeles ACO.

    (c) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the airplane to a location where 
the requirements of this AD can be accomplished.
    (d) This amendment becomes effective on March 30, 1998.

    Issued in Renton, Washington, on February 12, 1998.
Gilbert L. Thompson,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 98-4248 Filed 2-20-98; 8:45 am]
BILLING CODE 4910-13-U


Why this text is shown

The complete text was extracted from the official GovInfo HTML edition for this publication. Acquired 2026-10-09T05:05:45.520844+00:00. Text extraction preserves the recorded source wording; it does not determine current requirements.

Open the captured official edition

Source SHA-256
c9d058c9ce3d671b6ecb5117054366792c05df454ead0e9a40e29efd65b6076c
Text SHA-256
a901732f4027d92f7d090986d5a4be3e8eb5383f8d09d1fbeb1bbaeb895230a9

Return to the full metadata catalog · Search complete publication text · Explore retained publication text and evidence

Coverage and limits

These are dated publication metadata, recorded clauses and literal source observations. Word, model-label, header and reference matches do not establish current legal effect, manufacturer/model identity, aircraft applicability, installed configuration or compliance.

The collection uses 33 explicit annual source snapshots. Source captures and operative-text qualifications have separate states. Missing information remains unknown.