Airworthiness Directives; REIMS AVIATION S.A. Model F406 Airplanes

[Federal Register Volume 72, Number 247 (Thursday, December 27, 2007)]
[Rules and Regulations]
[Pages 73258-73260]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: E7-24638]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. FAA-2007-0115 Directorate Identifier 2007-CE-080-AD; 
Amendment 39-15310; AD 2007-26-08]
RIN 2120-AA64


Airworthiness Directives; REIMS AVIATION S.A. Model F406 
Airplanes

AGENCY: Federal Aviation Administration (FAA), Department of 
Transportation (DOT).

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: We are adopting a new airworthiness directive (AD) for the 
products listed above. This AD results from mandatory continuing 
airworthiness information (MCAI) issued by an aviation authority of 
another country to identify and correct an unsafe condition on an 
aviation product. The MCAI describes the unsafe condition as:

    On several occasions, leaks of the landing gear emergency 
blowdown bottle have been reported. Investigations revealed that the 
leakage was located on the nut manometer because of a design 
deficiency in the bottle head.
    If left uncorrected, the internal bottle pressure could not be 
maintained to an adequate level and could result in a malfunction, 
failing to extend landing gears during emergency situations.

We are issuing this AD to require actions to correct the unsafe 
condition on these products.

DATES: This AD becomes effective January 31, 2008.
    On January 31, 2008, the Director of the Federal Register approved 
the incorporation by reference of certain publications listed in this 
AD.

ADDRESSES: You may examine the AD docket on the Internet at http://www.regulations.gov or in person at Document Management Facility, U.S. 
Department of Transportation, Docket Operations, M-30, West Building 
Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC 
20590.

FOR FURTHER INFORMATION CONTACT: Mike Kiesov, Aerospace Engineer, FAA, 
Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 
64106; telephone: (816) 329-4144; fax: (816) 329-4090.

SUPPLEMENTARY INFORMATION: 

Discussion

    We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR 
part 39 to include an AD that would apply to the specified products. 
That NPRM was published in the Federal Register on October 31, 2007 (72 
FR 61578). That NPRM proposed to correct an unsafe condition for the 
specified products. The MCAI states:

    On several occasions, leaks of the landing gear emergency 
blowdown bottle have been reported. Investigations revealed that the 
leakage was located on the nut manometer because of a design 
deficiency in the bottle head.
    If left uncorrected, the internal bottle pressure could not be 
maintained to an adequate level and could result in a malfunction, 
failing to extend landing gears during emergency situations.

Comments

    We gave the public the opportunity to participate in developing 
this AD. We received no comments on the NPRM or on the determination of 
the cost to the public.

Conclusion

    We reviewed the available data and determined that air safety and 
the public interest require adopting the AD as proposed.

[[Page 73259]]

Differences Between This AD and the MCAI or Service Information

    We have reviewed the MCAI and related service information and, in 
general, agree with their substance. But we might have found it 
necessary to use different words from those in the MCAI to ensure the 
AD is clear for U.S. operators and is enforceable. In making these 
changes, we do not intend to differ substantively from the information 
provided in the MCAI and related service information.
    We might also have required different actions in this AD from those 
in the MCAI in order to follow FAA policies. Any such differences are 
highlighted in a NOTE within the AD.

Costs of Compliance

    We estimate that this AD will affect 7 products of U.S. registry. 
We also estimate that it will take about 1 work-hour per product to 
comply with basic requirements of this AD. The average labor rate is 
$80 per work-hour. Required parts will cost about $11,330 per product.
    Based on these figures, we estimate the cost of this AD to the U.S. 
operators to be $79,870 or $11,410 per product.

Authority for This Rulemaking

    Title 49 of the United States Code specifies the FAA's authority to 
issue rules on aviation safety. Subtitle I, section 106, describes the 
authority of the FAA Administrator. ``Subtitle VII: Aviation 
Programs,'' describes in more detail the scope of the Agency's 
authority.
    We are issuing this rulemaking under the authority described in 
``Subtitle VII, Part A, Subpart III, Section 44701: General 
requirements.'' Under that section, Congress charges the FAA with 
promoting safe flight of civil aircraft in air commerce by prescribing 
regulations for practices, methods, and procedures the Administrator 
finds necessary for safety in air commerce. This regulation is within 
the scope of that authority because it addresses an unsafe condition 
that is likely to exist or develop on products identified in this 
rulemaking action.

Regulatory Findings

    We determined that this AD will not have federalism implications 
under Executive Order 13132. This AD will not have a substantial direct 
effect on the States, on the relationship between the national 
government and the States, or on the distribution of power and 
responsibilities among the various levels of government.
    For the reasons discussed above, I certify this AD:
    (1) Is not a ``significant regulatory action'' under Executive 
Order 12866;
    (2) Is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and
    (3) Will not have a significant economic impact, positive or 
negative, on a substantial number of small entities under the criteria 
of the Regulatory Flexibility Act.
    We prepared a regulatory evaluation of the estimated costs to 
comply with this AD and placed it in the AD Docket.

Examining the AD Docket

    You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Management Facility 
between 9 a.m. and 5 p.m., Monday through Friday, except Federal 
holidays. The AD docket contains the NPRM, the regulatory evaluation, 
any comments received, and other information. The street address for 
the Docket Office (telephone (800) 647-5527) is in the ADDRESSES 
section. Comments will be available in the AD docket shortly after 
receipt.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

0
Accordingly, under the authority delegated to me by the Administrator, 
the FAA amends 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

0
1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec.  39.13  [Amended]

0
2. The FAA amends Sec.  39.13 by adding the following new AD:

2007-26-08 REIMS AVIATION S.A.: Amendment 39-15310; Docket No. FAA-
2007-0115; Directorate Identifier 2007-CE-080-AD.

Effective Date

    (a) This airworthiness directive (AD) becomes effective January 
31, 2008.

Affected ADs

    (b) None.

Applicability

    (c) This AD applies to F406 airplanes, all serial numbers, that 
are:
    (1) equipped with landing gear emergency blowdown bottle part 
number (P/N) 9910154-4; and
    (2) certificated in any category.

Subject

    (d) Air Transport Association of America (ATA) Code 32: Landing 
Gear.

Reason

    (e) The mandatory continuing airworthiness information (MCAI) 
states:
    On several occasions, leaks of the landing gear emergency 
blowdown bottle have been reported. Investigations revealed that the 
leakage was located on the nut manometer because of a design 
deficiency in the bottle head.
    If left uncorrected, the internal bottle pressure could not be 
maintained to an adequate level and could result in a malfunction, 
failing to extend landing gears during emergency situations.
The MCAI requires you to replace the old landing gear emergency 
blowdown bottle with a newly designed landing gear emergency 
blowdown bottle.

Actions and Compliance

    (f) Unless already done, within the next 12 calendar months 
after January 31, 2008 (the effective date of this AD) remove the 
emergency blowdown bottle P/N 9910154-4 and install the new 
emergency blowdown bottle P/N 4063700-1 using the accomplishment 
instructions of the REIMS AVIATION Industries Service Bulletin No.: 
F406-66, dated May 7, 2007.

FAA AD Differences

    Note: This AD differs from the MCAI and/or service information 
as follows: No differences.

Other FAA AD Provisions

    (g) The following provisions also apply to this AD:
    (1) Alternative Methods of Compliance (AMOCs): The Manager, 
Standards Office, FAA, has the authority to approve AMOCs for this 
AD, if requested using the procedures found in 14 CFR 39.19. Send 
information to ATTN: Mike Kiesov, Aerospace Engineer, FAA, Small 
Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 
64106; telephone: (816) 329-4144; fax: (816) 329-4090. Before using 
any approved AMOC on any airplane to which the AMOC applies, notify 
your appropriate principal inspector (PI) in the FAA Flight 
Standards District Office (FSDO), or lacking a PI, your local FSDO.
    (2) Airworthy Product: For any requirement in this AD to obtain 
corrective actions from a manufacturer or other source, use these 
actions if they are FAA-approved. Corrective actions are considered 
FAA-approved if they are approved by the State of Design Authority 
(or their delegated agent). You are required to assure the product 
is airworthy before it is returned to service.
    (3) Reporting Requirements: For any reporting requirement in 
this AD, under the provisions of the Paperwork Reduction Act (44 
U.S.C. 3501 et seq.), the Office of Management and Budget (OMB) has 
approved the information collection requirements and has assigned 
OMB Control Number 2120-0056.

[[Page 73260]]

Related Information

    (h) Refer to MCAI European Aviation Safety Agency (EASA) AD No.: 
2007-0190, dated July 12, 2007; and REIMS AVIATION INDUSTRIES 
Service Bulletin No.: F406-66, dated May 7, 2007, for related 
information.

Material Incorporated by Reference

    (i) You must use REIMS AVIATION INDUSTRIES Service Bulletin No.: 
F406-66, dated May 7, 2007, to do the actions required by this AD, 
unless the AD specifies otherwise.
    (1) The Director of the Federal Register approved the 
incorporation by reference of this service information under 5 
U.S.C. 552(a) and 1 CFR part 51.
    (2) For service information identified in this AD, contact REIMS 
AVIATION INDUSTRIES, A[eacute]rodrome de Reims Prunay, 51360 Prunay, 
France, A l'attention du Support Client; telephone: +33 
(0)3.26.48.46.53; fax: +33 (0)3.26.49.18.57.
    (3) You may review copies at the FAA, Central Region, Office of 
the Regional Counsel, 901 Locust, Room 506, Kansas City, Missouri 
64106; or at the National Archives and Records Administration 
(NARA). For information on the availability of this material at 
NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html.

    Issued in Kansas City, Missouri, on December 13, 2007.
John R. Colomy,
Acting Manager, Small Airplane Directorate, Aircraft Certification 
Service.
 [FR Doc. E7-24638 Filed 12-26-07; 8:45 am]
BILLING CODE 4910-13-P

The complete text was extracted from the official GovInfo HTML edition for this publication. Acquired 2026-10-09T03:34:08.951349+00:00. Text extraction preserves the recorded source wording; it does not determine current requirements.

Open the captured official edition

Source SHA-256

a38d3c4c4cd48f821793da40b78fa8cd260a9e26649ad206c176598387774148

Text SHA-256

cfcb8a8d1c8ee2e0810afc0d907c81879b468bbf9cfec8355889020b5bd78211