Airworthiness Directives; Bombardier Model DHC-8-400 Series Airplanes

[Federal Register Volume 74, Number 14 (Friday, January 23, 2009)]
[Rules and Regulations]
[Pages 4131-4133]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: E9-320]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. FAA-2008-1083; Directorate Identifier 2008-NM-130-AD; 
Amendment 39-15782; AD 2009-01-03]
RIN 2120-AA64


Airworthiness Directives; Bombardier Model DHC-8-400 Series 
Airplanes

AGENCY: Federal Aviation Administration (FAA), Department of 
Transportation (DOT).

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: We are adopting a new airworthiness directive (AD) for the 
products listed above. This AD results from mandatory continuing 
airworthiness information (MCAI) originated by an aviation authority of 
another country to identify and correct an unsafe condition on an 
aviation product. The MCAI describes the unsafe condition as:

    There have been several cases reported where the landing gear 
did not retract after take-off. Subsequent investigation revealed 
this was caused by fatigue failure of the nose landing gear 
electrical harness. In conjunction with one engine being inoperable, 
this could, in certain operating conditions, affect continued safe 
flight and landing.

We are issuing this AD to require actions to correct the unsafe 
condition on these products.

DATES: This AD becomes effective February 27, 2009.
    The Director of the Federal Register approved the incorporation by 
reference of a certain publication listed in this AD as of February 27, 
2009.

ADDRESSES: You may examine the AD docket on the Internet at http://www.regulations.gov or in person at the U.S. Department of 
Transportation, Docket Operations, M-30, West Building Ground Floor, 
Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC.

FOR FURTHER INFORMATION CONTACT: Wing Chan, Aerospace Engineer, Systems 
and Flight Test Branch, ANE-172, FAA, New York Aircraft Certification 
Office, 1600 Stewart Avenue, Suite 410, Westbury, New York 11590; 
telephone (516) 228-7311; fax (516) 794-5531.

SUPPLEMENTARY INFORMATION: 

Discussion

    We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR 
part 39 to include an AD that would

[[Page 4132]]

apply to the specified products. That NPRM was published in the Federal 
Register on October 10, 2008 (73 FR 60206). That NPRM proposed to 
correct an unsafe condition for the specified products. The MCAI 
states:

    There have been several cases reported where the landing gear 
did not retract after take-off. Subsequent investigation revealed 
this was caused by fatigue failure of the nose landing gear 
electrical harness. In conjunction with one engine being inoperable, 
this could, in certain operating conditions, affect continued safe 
flight and landing.
    This directive mandates incorporation of new weight-on-wheels 
(WOW) and steering harnesses that have a new conduit construction.

You may obtain further information by examining the MCAI in the AD 
docket.

Comments

    We gave the public the opportunity to participate in developing 
this AD. We received no comments on the NPRM or on the determination of 
the cost to the public.

Conclusion

    We reviewed the available data and determined that air safety and 
the public interest require adopting the AD as proposed.

Differences Between This AD and the MCAI or Service Information

    We have reviewed the MCAI and related service information and, in 
general, agree with their substance. But we might have found it 
necessary to use different words from those in the MCAI to ensure the 
AD is clear for U.S. operators and is enforceable. In making these 
changes, we do not intend to differ substantively from the information 
provided in the MCAI and related service information.
    We might also have required different actions in this AD from those 
in the MCAI in order to follow our FAA policies. Any such differences 
are highlighted in a NOTE within the AD.

Costs of Compliance

    We estimate that this AD will affect about 42 products of U.S. 
registry. We also estimate that it will take about 13 work-hours per 
product to comply with the basic requirements of this AD. The average 
labor rate is $80 per work-hour. Required parts will cost about $0 per 
product. Where the service information lists required parts costs that 
are covered under warranty, we have assumed that there will be no 
charge for these parts. As we do not control warranty coverage for 
affected parties, some parties may incur costs higher than estimated 
here. Based on these figures, we estimate the cost of this AD to the 
U.S. operators to be $43,680, or $1,040 per product.

Authority for This Rulemaking

    Title 49 of the United States Code specifies the FAA's authority to 
issue rules on aviation safety. Subtitle I, section 106, describes the 
authority of the FAA Administrator. ``Subtitle VII: Aviation 
Programs,'' describes in more detail the scope of the Agency's 
authority.
    We are issuing this rulemaking under the authority described in 
``Subtitle VII, Part A, Subpart III, Section 44701: General 
requirements.'' Under that section, Congress charges the FAA with 
promoting safe flight of civil aircraft in air commerce by prescribing 
regulations for practices, methods, and procedures the Administrator 
finds necessary for safety in air commerce. This regulation is within 
the scope of that authority because it addresses an unsafe condition 
that is likely to exist or develop on products identified in this 
rulemaking action.

Regulatory Findings

    We determined that this AD will not have federalism implications 
under Executive Order 13132. This AD will not have a substantial direct 
effect on the States, on the relationship between the national 
government and the States, or on the distribution of power and 
responsibilities among the various levels of government.
    For the reasons discussed above, I certify this AD:
    1. Is not a ``significant regulatory action'' under Executive Order 
12866;
    2. Is not a ``significant rule'' under the DOT Regulatory Policies 
and Procedures (44 FR 11034, February 26, 1979); and
    3. Will not have a significant economic impact, positive or 
negative, on a substantial number of small entities under the criteria 
of the Regulatory Flexibility Act.
    We prepared a regulatory evaluation of the estimated costs to 
comply with this AD and placed it in the AD docket.

Examining the AD Docket

    You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Operations office 
between 9 a.m. and 5 p.m., Monday through Friday, except Federal 
holidays. The AD docket contains the NPRM, the regulatory evaluation, 
any comments received, and other information. The street address for 
the Docket Operations office (telephone (800) 647-5527) is in the 
ADDRESSES section. Comments will be available in the AD docket shortly 
after receipt.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

0
Accordingly, under the authority delegated to me by the Administrator, 
the FAA amends 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

0
1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec.  39.13   [Amended]

0
2. The FAA amends Sec.  39.13 by adding the following new AD:

2009-01-03 Bombardier, Inc. (Formerly de Havilland, Inc.): Amendment 
39-15782. Docket No. FAA-2008-1083; Directorate Identifier 2008-NM-
130-AD.

Effective Date

    (a) This airworthiness directive (AD) becomes effective February 
27, 2009.

Affected ADs

    (b) None.

Applicability

    (c) This AD applies to Bombardier Model DHC-8-400, DHC-8-401, 
and DHC-8-402 airplanes, certificated in any category, serial 
numbers 4003, 4004, 4006, and 4008 through 4184 inclusive.

Subject

    (d) Air Transport Association (ATA) of America Code 32: Landing 
Gear.

Reason

    (e) The mandatory continuing airworthiness information (MCAI) 
states:

    ``There have been several cases reported where the landing gear 
did not retract after take-off. Subsequent investigation revealed 
this was caused by fatigue failure of the nose landing gear 
electrical harness. In conjunction with one engine being inoperable, 
this could, in certain operating conditions, affect continued safe 
flight and landing.
    ``This directive mandates incorporation of new weight-on-wheels 
(WOW) and steering harnesses that have a new conduit construction.''

Actions and Compliance

    (f) Unless already done, do the following actions.
    (1) Within 2,500 flight hours after the effective date of this 
AD, replace the WOW and steering harnesses by incorporating Modsum 
4-126401, in accordance with the Accomplishment Instructions of 
Bombardier Service Bulletin 84-32-51, Revision `B,' dated December 
17, 2007.
    (2) Actions done before the effective date of this AD in 
accordance with Bombardier

[[Page 4133]]

Service Bulletin 84-32-51, dated August 16, 2007; or Revision `A,' 
dated August 22, 2007; are acceptable for compliance with the 
corresponding requirements of this AD.

FAA AD Differences

    Note: This AD differs from the MCAI and/or service information 
as follows: No differences.

Other FAA AD Provisions

    (g) The following provisions also apply to this AD:
    (1) Alternative Methods of Compliance (AMOCs): The Manager, New 
York Aircraft Certification Office, ANE-172, FAA, has the authority 
to approve AMOCs for this AD, if requested using the procedures 
found in 14 CFR 39.19. Send information to ATTN: Wing Chan, 
Aerospace Engineer, Systems and Flight Test Branch, ANE-172, FAA, 
New York Aircraft Certification Office, 1600 Stewart Avenue, Suite 
410, Westbury, New York 11590; telephone (516) 228-7311; fax (516) 
794-5531. Before using any approved AMOC on any airplane to which 
the AMOC applies, notify your appropriate principal inspector (PI) 
in the FAA Flight Standards District Office (FSDO), or lacking a PI, 
your local FSDO.
    (2) Airworthy Product: For any requirement in this AD to obtain 
corrective actions from a manufacturer or other source, use these 
actions if they are FAA-approved. Corrective actions are considered 
FAA-approved if they are approved by the State of Design Authority 
(or their delegated agent). You are required to assure the product 
is airworthy before it is returned to service.
    (3) Reporting Requirements: For any reporting requirement in 
this AD, under the provisions of the Paperwork Reduction Act, the 
Office of Management and Budget (OMB) has approved the information 
collection requirements and has assigned OMB Control Number 2120-
0056.

Related Information

    (h) Refer to MCAI Canadian Airworthiness Directive CF-2008-22, 
dated June 24, 2008; and Bombardier Service Bulletin 84-32-51, 
Revision `B,' dated December 17, 2007; for related information.

Material Incorporated by Reference

    (i) You must use Bombardier Service Bulletin 84-32-51, Revision 
`B,' dated December 17, 2007, to do the actions required by this AD, 
unless the AD specifies otherwise.
    (1) The Director of the Federal Register approved the 
incorporation by reference of this service information under 5 
U.S.C. 552(a) and 1 CFR part 51.
    (2) For service information identified in this AD, contact 
Bombardier, Inc., 400 C[ocirc]te-Vertu Road West, Dorval, Quebec H4S 
1Y9, Canada; telephone 514-855-5000; fax 514-855-7401; e-mail 
[email protected]; Internet http://www.bombardier.com.
    (3) You may review copies of the service information that is 
incorporated by reference at the FAA, Transport Airplane 
Directorate, 1601 Lind Avenue, SW., Renton, Washington. For 
information on the availability of this material at the FAA, call 
425-227-1221 or 425-227-1152.
    (4) You may also review copies of the service information at the 
National Archives and Records Administration (NARA). For information 
on the availability of this material at NARA, call 202-741-6030, or 
go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html.

    Issued in Renton, Washington, on December 28, 2008.
Linda Navarro,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. E9-320 Filed 1-22-09; 8:45 am]
BILLING CODE 4910-13-P

The complete text was extracted from the official GovInfo HTML edition for this publication. Acquired 2026-10-09T03:25:58.995226+00:00. Text extraction preserves the recorded source wording; it does not determine current requirements.

Open the captured official edition

Source SHA-256

62a11d28e4f7c754ae009fae0a1b7b38785c7b55679ff6e12e5b6775a98fd0a7

Text SHA-256

681b49871cd8188c57eb6a71d29ef52c9c8452a6e096ec92151ab0f138d6de1e